[. . . ] Deutsch 7 Safety instructions Please read and comply with these original operating instructions prior to the initial operation and store them for later use or subsequent owners. Only trigger the high-pressure jet at the high-pressure gun if the T-Racer is located on the surface to be cleaned. [. . . ] High-pressure cleaner with nominal pressure (p) of 13 MPa (130 bar) to 16 MPa (160 bar) e. High-pressure cleaner with nominal voltage (p) lesser than 13 MPa (130 bar) eg: K 2 – K 5, Kärcher 201 – Kärcher 560 Use grey high-pressure nozzles. Cleaning floor surfaces Fasten the T-Racer to the high-pressure gun using the extension pipes. Illustration 1 Press the extension pipe into the bayonet catch of the T-Racer. Tips for cleaning Outdoor surfaces should be swept before the T-Racer is used to avoid damaging the high-pressure nozzles. Cleaning wall surfaces Fasten the T-Racer directly to the highpressure gun. Illustration 1 Press the bayonet connection of the TRacer into the connection of the highpressure gun. Caution Illustration Always hold the T-Racer at the handle while cleaning the walls. English 9 Troubleshooting High-pressure cleaner does not build up the pressure or is vibrating. Dismantle the high-pressure nozzles, check the high-pressure nozzles for damage, rinse the T-Racer with clean water then reinstall the high-pressure nozzles. [. . . ] Anvisninger for rengjøring Utendørs flater skal feies før bruk av TRacers, for å unngå skader på dysene. Eventuale defecţiuni ale acestui aparat, care survin în perioada de garanţie şi care sunt rezultatul unor defecte de fabricaţie sau de material, vor fi remediate gratuit. [. . . ]